| 1. |
Have this insert installed by an avionics shop if you do
not have all the proper tools, are not a qualified
technician or are not sure you are capable of doing this
job. |
| 2. |
Turn all knobs counter clockwise to
their stops. Make a sketch or digital photo of the 4
knobs, their knob graphics and the text on the 8 switches
so that they will be in the correct positions when
reassembled.
|
| 3. |
Remove the four knobs by prying off
the top caps which covers a hidden screw in the center of
each knob. Hold the knob with pliers, careful not to
damage them. Do not remove the screws. Loosen them only
until the knobs slide off. |
| 4. |
Check that the fit of the new
faceplate insert is good before removing the old one. |
| 5. |
Use a small screwdriver to pry off
the faceplate from the lockdown holes. |
| 6. |
Remove the 8 buttons and
place them in the same order as on the radar unit. |
| 7. |
Scrap off any excess glue
residue that may interfere with the new insert seating to
the bottom. |
| 8. |
Double check that the new insert fits
correctly. |
| 9. |
If your faceplate is gray
and you want it black or if it needs painting, follow
directions 10a thru 10f. Otherwise go to #11. |
| 10a. |
Fill any dents with a auto
body plastic filler or similar material. |
| 10b. |
Lightly sand with a fine
grit sandpaper for good paint adhesion. |
| 10c. |
Clean the areas that need
painting with alcohol. |
| 10d. |
Tape off the 2 inner cavities where
the knobs were, the display screen and the metal housing
body of the unit. |
| 10e. |
Paint the faceplate housing
with light thin coats of a quality paint such as Krylon'sŪ 1613 Semi-Flat
Black paint. |
| 10f. |
When the paint is dry,
remove the protective tape. |
| 11. |
Place the 8 push buttons on their
respective positions. |
| 12. |
Remove the double face tape backing
from the new insert. |
| 13. |
Place the new inserts into faceplate
housing making sure the 8 buttons come through correctly.
Press FIRMLY all around to assure good tape adhesion.
Reinstall the knobs and their respective tops. |
| 14. |
Tell all your aircraft buddies about Aircraft Engravers and place the enclosed sticker on the metal case for future
reference. |
